Main Product Introduction
The 1000-2000MHz 2-Way Power Splitter is a high-performance passive device optimized for the 1-2GHz spectrum. By narrowing the focus to the L-band, this splitter delivers lower insertion loss and superior impedance matching than broader models. It is built using a high-grade microstrip architecture that maintains tight phase and amplitude consistency, which is vital for satellite navigation and cellular sampling. Its 50W power rating and rugged SMA-Female connectors make it a reliable choice for both laboratory test benches and field-deployed communication systems.
Application Scenarios
- GNSS/GPS Signal Distribution: Splitting a single GPS antenna feed to two separate receivers or timing servers.
- DCS/PCS Cellular Systems: Signal distribution for 1800MHz and 1900MHz indoor coverage or base station monitoring.
- Satellite Telemetry: Reliable power division for L-band satellite ground station equipment.
- RF Lab Testing: Providing synchronized signal inputs for testing L-band amplifiers, filters, and transceivers.
Electrical Specifications
| Parameters | Specifications |
|---|---|
| Frequency Range | 1000 – 2000 MHz |
| Output Port Number | 2-Way |
| Insertion Loss | ≤ 3.5 dB (Including theoretical split loss) |
| Isolation | ≥ 20 dB |
| VSWR | ≤ 1.25 |
| Nominal Impedance | 50 Ω |
| Connector Type | SMA Female (1 Input, 2 Outputs) |
| Color / Finish | Silver (Aluminum Oxide/Nickel Plated) |
FAQ
- What is the insertion loss for this 1000-2000MHz model?
- Thanks to its L-band optimization, the insertion loss is extremely low, typically ≤0.3 dB (beyond the theoretical 3.0 dB split loss). This ensures minimal signal degradation across the chain.
- Can I use this splitter for 2.4GHz Wi-Fi?
- No. This model is frequency-tuned for 1000-2000MHz. Using it at 2400MHz will result in increased VSWR and higher insertion loss. Please select our 2-6GHz or 0.6-6GHz models for Wi-Fi applications.
- How do I handle an unused port?
- IMPORTANT: For optimal performance, any unused output port must be terminated with a 50-ohm SMA dummy load. This preserves the isolation and prevents signal reflections back to the source.
- Does this support DC pass for active GPS antennas?
- The standard configuration is DC-blocked. If you need to pass DC power to a remote active antenna, please contact us for a DC-Pass version.
- Is it bi-directional?
- Yes, it can be used as a 2-way combiner. Note that for high-power combining, the input signals should be in-phase to minimize heat generation in the internal balance resistor.
Recommended products
700-6000MHz 50W 2Way Power Splitter SMA Female
Power Splitter790-2700MHz 200W 2/3/4Way Cavity Power Splitter
Power Splitter30W 698-6000MHz 16Way Power Splitter
Power Splitter380-3000MHz 4Way Power Splitter with SMA Female
Power Splitter














